Adjusting Handlebar And Brake Lever - Woom ORIGINAL 4 Bedienungsanleitung

Checking
ATTENTION

Before each ride, check that the front and rear brakes work and that the tyres have
sufficient pressure.
6�3 Adjusting handlebar and brake lever
See Section 11.1 on page 52 for tightening torques.
Once you've assembled all the parts, the woom ORIGINAL is ready to go. The following ad-
justments are only necessary if you find that the position of the brake lever or the inclination
of the handlebar is not suitable for your child.
Adjusting the brake lever position and grip width
The distance from the brake lever to the handlebar grip is set to a default value depending
on the woom ORIGINAL model.
To reduce the distance between the brake lever and the handlebar grip, turn the brake lever
adjusting screw (1– see figure) clockwise with a cross-head screwdriver. To increase the dis-
tance, turn the screw counter clockwise (observe the warning!).
To adjust the position of the brake lever on the handlebar,
loosen the clamping screw (2 – see figure) by turning it counter
clockwise and reposition the lever. Then tighten the clamping
screw to the recommended torque. Ensure that the brake
levers are positioned in such a way that your child can brake
safely and easily.
ATTENTION
The brake lever must not touch the handlebar grip, even when applying maximum

strength. Screw the adjusting screw counter clockwise but ensure that the brake lever
does not touch the handlebar grip even when the brake is applied with maximum
strength. Never unscrew the adjusting screw completely from the brake lever.
43