Gearshift System - Woom ORIGINAL 4 Bedienungsanleitung

9�4 Gearshift system
Over time, the gearshift system may change. Therefore, it may be necessary to readjust it
after some time.
If an accident or other event causes problems with the gearshift system, it must be repaired
or readjusted by a specialist.
Adjust the rear derailleur
Lower limit: Shift to the smallest sprocket and adjust the rear derailleur (1) by turning the
screw (H) so that it is in line under the smallest sprocket.
Upper limit: Shift to the largest sprocket and adjust the rear derailleur (1) by turning the screw
(H) so that it is in line under the largest sprocket.
Turning the screw (H) clockwise and the screw
(L) counter clockwise moves the rear derailleur
(1) toward the wheel.
Shifting:
Shift through all the gears starting with the smallest
sprocket. If the chain does not shift to the next-largest
sprocket, increase the shift cable tension by turning the
adjustment screw (2) on the shifter counter clockwise.
If, during a single shift operation, the chain skips several
sprockets, reduce the shift cable tension by turning the
adjustment screw (2) on the shifter clockwise.
Please also read the information on the gearshift sys-
tem on the following website: www.sram.com/service
Turning the screw (H) counter clockwise and the
screw (L) clockwise moves the rear derailleur (1)
away from the wheel.
49