Endress+Hauser Prosonic Flow E 100 Einbauanleitung Seite 10

EA01219D
8.3 Replacing the electronics module
Proceed as described in Section 8.1 →  9 or in Section 8.2 or in Section 8.3 →  9 and as
illustrated in the diagrams below.
When replacing electronics, do not forget to detach the T-DAT (item 1. in Fig. 1 below).
The T-DAT is secured to the housing by a cable tie and must be plugged back in following
assembly. Otherwise the device parameters will be lost!
1 →
1.
4
T10
1.
8.3.1 Reassembling the transmitter
Reassembly is carried out in reverse order.
The material specification 1.4404-316L is engraved in the cover. If this information is
missing, then the material is 1.4301-304.
10
2 →
2.
2.
T8
1.
T10
2.
3 →
1.
Endress+Hauser
2.