Electrolux WA SL3 E 102 Benutzerinformation Seite 51

4. Screw the hose back onto the tap.
Make sure the connection is tight.
5. Unscrew the hose from the machine.
Keep a rug nearby because some water
may flow.
6. Clean the filter in the valve with a stiff
brush or with the piece of cloth.
7. Screw the hose back to the machine
and make sure the connection is tight.
All manuals and user guides at all-guides.com
8. Turn on the water tap.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has
4. open the pump door;
5. place a bowl on the floor and place the
6. clean the pump if necessary as previous-
7. replace the emergency emptying hose
8. screw the pump again and close the
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C, pro-
ceed as follows:
1. close the water tap and unscrew the wa-
2. place the end of the emergency empty-
3. screw the water inlet hose back on and
By doing this, any water remaining in the ma-
chine is removed, avoiding ice forming and
consequently damage to the appliance.
When you use the machine again, make
sure that the ambient temperature is above
0°C.
cooled down;
end of the emergency emptying hose in-
to the bowl. Remove its cap. The water
should drain by gravity into the bowl.
When the bowl is full, put the cap back
on the hose. Empty the bowl. Repeat
the procedure until water stops flowing
out;
ly described;
in its seat after having plugged it;
door.
ter inlet hose from the tap;
ing hose and that of the inlet hose in a
bowl placed on the floor and let water
drain out;
reposition the emergency emptying
hose after having put the cap on again.
electrolux 51