Electrolux WA SL3 E 102 Benutzerinformation Seite 43

gramme will start after the selected delay
has expired.
You can cancel the delay time at any mo-
ment, before you press the button 7 .
Cancelling the delayed start:
• set the appliance to PAUSE by pressing
the button 7 ,
• press the button 8 until the symbol
appears on the display,
• press the button 7 again to start the pro-
gramme.
The DELAY START option can not be selec-
ted with DRAIN or SPIN programmes.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out. Be-
fore you make any change, you must pause
the appliance by pressing the button 7 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to and then to the new pro-
gramme position. Press the button 5 to can-
cel the previous washing programme. Start
the new programme by pressing the button
7 again. The washing water in the tub will
be not emptied out.
Interrupting a programme
Press the button 7 to interrupt a pro-
gramme which is running, the correspond-
ing light starts blinking. Press the same but-
ton again to restart the programme.
Cancelling a programme
Turn the selector dial to
new selected programme.
Press the button 5 to cancel the pro-
gramme which is running.
Now press the button 7 to start the new pro-
gramme.
Opening the door after the programme
has started
First set the machine to Pause by pressing
the button 7 .
• If the display says that the appliance is in
pause, the door can be opened
• If the display says alternately that the ap-
pliance is in pause and the door is
locked, this means that the machine is al-
Stand by : once the programme has finish-
ed after a few minutes the energy saving sys-
All manuals and user guides at all-guides.com
• If you cannot open the door but you need
dis-
After closing the door, it is necessary to se-
lect the previous programme again and to
press the button 7 , the machine will re-
sume the programme from the point where
it had been interrupted.
At the end of the programme
The machine stops automatically. The pilot
light of the button 7 goes off, a static
appears on the display and the acoustic sig-
nal sounds for some minutes.
If the RINSE HOLD or NIGHT CYCLE op-
tion has been selected, the pilot light of the
button 7 goes off, the display says that the
door is locked and the RINSE HOLD option
has been selected, the door is blocked to in-
dicate that the water must be emptied out.
Please follow the below instructions to
empty out the water:
• turn the programme selector dial to
• select the DRAINING or SPINNING pro-
• reduce the spin speed if needed, by
and then in the
• press the button 7 ,
• when the programme has finished the dis-
Turn the programme selector dial to
OFF to switch the machine off. Remove the
laundry from the drum and carefully check
that the drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
tem will be enabled. The brightness of the
display is reduced. By pressing any button
ready heating, that the water level is
above the bottom edge of the door or
that the drum is turning: in this case the
door can not be opened
to open it you have to switch the ma-
chine off by turning the selector dial to
. After about some minutes the door
can be opened (pay attention to the wa-
ter level and temperature!) .
OFF,
gramme and confirm it by pressing but-
ton 5 ,
means of the relevant button,
play shows a static
play says that the programme is finished.
The door can be opened.
electrolux 43
/
and the dis-
/