Vaisala Indigo500-Serie Kurzanleitung Seite 26

Starting up transmitter using web
interface
The transmitter has a web interface for remote access. Take the following steps to start using
the transmitter via the web interface.
Start up the non-display transmitter model using instructions in chapter
Connecting to web interface with a direct connection between transmitter and
computer (page
For information on configuring the home views and outputs and updating the transmitter
software via the web interface, see Indigo500 Series User Guide (M212287EN), available at
www.vaisala.com.
Connecting to web interface
Computer with:
• RJ45 Ethernet connector
• Web browser, for example, Firefox, Chrome, or Safari. Using the most recent
version is recommended.
1. Connect your computer to the same network as the transmitter.
2. Power up the transmitter.
Powering up takes some minutes.
3. Select the configuration menu symbol at the upper right corner of the touchscreen.
4. In Transmitter > Network, configure the network connection.
For instructions on configuring the network connection, see
connection on touchscreen (page
If you have already configured the network connection, you can move to
24
25).
21).
Figure 9 Web interface, Measurements view
Configuring network
step 5.
M212290EN-C