Jet SSG-8-M Gebrauchsanleitung Seite 3

GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been
prepared for the owner and operators of a JET JSSG-8-M wet sharpener to promote safety during installation, operation and
maintenance procedures. Please read and understand the information contained in these operating instructions and the
accompanying documents. To obtain maximum life and efficiency from your machine, and to use the machine safely, read this
manual thoroughly and follow instructions carefully.
...Table of Contents
1. Declaration of conformity
2. Safety
Authorized use
General safety notes
Remaining hazards
3. Machine specifications
Technical data
Noise emission
Contents of delivery
Machine description
4. Transport and start up
Transport and installation
Assembly
Mains connection
Starting operation
5. Machine operation
Stone wheel dressing
Tool grinding
Tool honing
6. Setup and adjustments
Sharpening jig setup
Torque adjustment
Changing the stone wheel
Changing the honing wheel
7. Maintenance and inspection
8. Trouble shooting
9. Environmental protection
10. Available accessories
1. Declaration of conformity
On our own responsibility we hereby
declare that this product complies
with the regulations listed on page 2.
2. Safety
2.1 Authorized use
This machine is designed for grinding
and sharpening of tools only.
Machining of other materials is not
permitted and may be carried out in
specific cases only after consulting
with the manufacturer.
For machining the tools must allow to
safely be loaded and guided.
The proper use also includes
compliance with the operating and
maintenance instructions given in this
manual.
The machine must be operated only by
persons familiar with its operation and
maintenance and who are familiar
with its hazards.
The required minimum age must be
observed
The machine must only be used in a
technically perfect condition.
When working on the machine, all
safety mechanisms and covers must be
mounted.
In addition to the safety requirements
contained in these operating
instructions and your country's
applicable regulations, you should
observe the generally recognized
technical rules concerning the
operation of metalworking machines.
Any other use exceeds authorization.
In the event of unauthorized use of the
machine, the manufacturer renounces
all liability and the responsibility is
transferred exclusively to the
operator.
2.2 General safety notes
3
Metalworking machines can be
dangerous if not used properly.
Therefore the appropriate general
technical rules as well as the following
notes must be observed.
Read and understand the entire
instruction manual before attempting
assembly or operation.
Keep this operating instruction close
by the machine, protected from dirt
and humidity, and pass it over to the
new owner if you part with the tool.
No changes to the machine may be
made.
Daily inspect the function and
existence of the safety appliances
before you start the machine.
Do not attempt operation in this case,
protect the machine by unplugging the
mains cord.
Remove all loose clothing and confine
long hair.
Before operating the machine, remove
tie, rings, watches, other jewellery,
and roll up sleeves above the elbows.
Wear safety shoes; never wear leisure
shoes or sandals.
Always wear the approved working
outfit
- safety goggles
- ear protection.
Use safety goggles at all times.
Tools are sharp and can lead to heavy
injuries, always handle them with care.
Tools to be sharpened must be held in
the appropriate fixture and be guided
firmly so it can not move and fly off
during the sharpening operation.
Never perform any operation
freehand.