Multitab Function - Electrolux ESF65710 Benutzerinformation

Multitab function

This appliance is equipped with the "Multitab
function", that allows the use of the "Multitab"
combi detergent tablets.
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
They can also contain other different agents
depending on which kind of tablets you
choose ("3 in 1", "4 in 1", "5 in 1" etc...).
Check whether these detergents are suitable
for your water hardness. See the manufac-
turers instructions.
Once this function is selected it will remain
active for all following wash programmes.
With the selection of this function the inflow
of rinse aid and salt from each respective
supply container is automatically deactivated
and also the indicator lights for salt and rinse
aid are deactivated.
When using the "Multitab function", the cycle
durations may change.
Activate/deactivate the ''Multitab func-
tion'' before the start of a washing pro-
gramme.
Once the programme is running, the
"Multitab function " can NO longer be
changed. If you want to cancel the "Mul-
titab function " you have to cancel the
programme setting and then deactivate
the ''Multitab function''. In this case you
have to set a washing programme (and
desired options) again.
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Activation/deactivation of the Multitab
function
Simultaneously press and hold the two Mul-
titab buttons (function buttons D and E) until
the Multitab indicator light comes on. This
means that the function is active.
To deactivate the function press the same
buttons again until the indicator light corre-
sponding to the Multitab function symbol
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A , B, and C start flashing.
3. Press function button B, the lights of
function buttons A and C go off while the
light of function button B continues to
flash.
4. To activate the rinse aid dispenser, press
button B again, the End indicator light
electrolux 37