Snooze Function; Temperature Alarm Setting; Receiving Measurements Automatically - National Geographic WIFI Weather Center 7in1 Bedienungsanleitung

2. Press the ALARM button again to activate the alarm.
3. Press the ALARM button one more time to activate the alarm with ice alert.
4. With activated ice alert, the alarm will sound 30 minutes earlier if outside temperature is below -3°
C.
5. To disable the alarm and ice alert, press the ALARM button until the alarm icons disappear.
Set Alarm time
6. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
7. Digits to be set are flashing.
8. Press UP or DOWN button to change the value.
9. Press ALARM button to confirm and continue to the next setting.
10. Settings order: Hours > Minutes
11. Finally press the ALARM button to save the settings and exit the setting mode.

25 Snooze function

1. When the alarm sound starts, press the ALARM/SNOOZE button to activate the Snooze function.
The Alarm will sound again after 5 minutes.
2. When the alarm sound starts, press the ALARM button or press and hold the ALARM/SNOOZE
button for approx. 3 seconds, to stop the alarm.
3. The alarm will be turned off automatically if no button is pressed within 2 minutes.

26 Temperature alarm setting

The temperature alarm can alert you to certain weather conditions. As soon as an alarm criterion is
met, the alarm tone is activated and the alarm icon flashes on the display.
1. Press the CHANNEL button on the base station repeatedly to select the desired outdoor sensor.
2. Press the ALERT button in the normal time display mode to enter the temperature alarm setting
mode.
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press the ALERT button to confirm and switch to the next setting.the next setting.
6. If no setting has been made after 30 seconds, the temperature setting mode is automatically
closed. The settings made up to that point are saved. Alternatively, any button on the front panel
can be pressed.
Activate/deactivate temperature alarm
7. Press the ALERT button repeatedly to display the selected temperature limits.
8. Press the ALARM button to enable or disable the alarm for the currently selected temperature
limit.
9. When the outdoor temperature reaches one of the limits, the temperature alarm symbol flashes
and a warning tone sounds for about 5 seconds. This is repeated every 1 minute until the temper-
ature falls below the limit value again.
10. When the alarm sounds, press any button to stop the alarm.

27 Receiving measurements automatically

Once power is restored, the base station will begin to display indoor readings and the first readings re-
ceived from the outdoor sensor will be displayed within approximately 3 minutes of commissioning.
51 / 96