Troubleshooting - Krups BeerTender VB700E00 Bedienungsanleitung

12 Troubleshooting

Problem Possible causes
The appliance The appliance is
does not turn not connected to
on. the mains power
supply.
You can The BeerTender
not fit the Keg tap has been
BeerTender activated by hand.
Keg tap in the
tapping unit.
You can not The BeerTender
close the tap Keg tap is not
cover. inserted correctly.
No beer The BeerTender
is being Keg is empty (last
dispensed. level of volume
indicator is blinking).
There is no
keg inside the
BeerTender
appliance (the
4 levels of the
volume indicator
are blinking).
The BeerTender
appliance tap
handle is not
correctly installed/
positioned.
The The BeerTender
BeerTender Keg has not
appliance reached the
produces right dispensing
too much temperature.
foam when
dispensing
beer (see also
chapter 7:
Dispensing
beer).
19
Remedies
Connect the
appliance to the
power supply.
Put the
BeerTender Keg
tap back in its
original position.
Remove the
BeerTender Keg
tap from the
appliance and fit
it again following
chapter 6 – Using
the BeerTender.
Replace the
BeerTender Keg
with a new one.
Install a keg inside
the BeerTender
appliance.
Install/position the
tap correctly.
Allow the
BeerTender Keg
to cool to the
right temperature.
You can rely on
the temperature
indicator on the
control display of
your BeerTender
appliance.