Use And Maintenance - Concept CP3010 Bedienungsanleitung

EN
Release button
Steam mop control
1. Attach the cleaning cloth on the steam mop cover holder.
2. Attaching the steam mop cover holder: Place the cover holder in the centre of the nozzle and push it slightly until
it clicks into its place.
NOTE: Never use the steam cleaner without the microfibre cover properly fitted.
3. When cleaning carpets, always use a carpet glider. Remove the carpet glider when using the steam cleaner on
hard floors.
4. Grasp the water tank release levers, pull it forward and remove it (Fig. 4).
5. Loosen the plug on the back of the water tank and fill the tank with water. Make sure that the plug is properly
closed. Place the water tank back into the appliance.
NOTE: Do not use the steam mop if there is no water in the water tank.
6. Press the button to turn on the steam. The Steam ready indicator ("READY") is flashing (Fig. 5).
7. After the steam heats up (the "READY" indicator is on), use the Steam intensity buttons to set the intensity to either
HIGH for high intensity or LOW for low intensity.
8. Once you have set the steam intensity, press the steam release lock so you can press the steam release lever and
start steam cleaning.
9. When the steam mop stops producing hot steam, switch off the appliance and fill the water tank with water.
10. Steam setting:
Tiles/stone - maximum Sealed wood floor - minimum
NOTE: If the microfibre cover is too wet or dirty, replace it with a clean one.
The microfibre cover can be washed in a washing machine at 40 °C.
58
Fig. 3
CP3010
Fig. 4

USE AND MAINTENANCE

Maintenance
1. After you have finished cleaning, switch off the appliance and unplug the power cord.
2. Pour the remaining water out of the water tank.
3. Remove the microfibre steam mop cover holder. The microfibre cover can be washed in a washing machine at
a temperature up to 100 °C. If the cover is very dirty, let it soak in warm water with detergent or stain remover. Allow
the cover to dry before storing it. NOTE: DO NOT USE FABRIC SOFTENER.
Replacing the water filter
The water filter helps to filter out minerals contained in water which reduce the efficiency of the steam cleaner. The filter
should be changed every 80-100 hours, depending on the frequency of the use of the appliance. Pour only distilled
water into the steam mop. If you live in an area with hard water, deposits of this water may form on the heating element,
which will then reduce the performance of the cleaner. Use only distilled water. By doing so, you will extend the life of
the water filter and the heating element.
WARNING: Unplug the appliance before performing any maintenance.
Dust container filter maintenance
Remove the dust container from the vacuum cleaner. Remove the filter unit from the dust container. Turn the coarse
outer filter counterclockwise and remove it. Pull out the dust container filter from the top part. Wash all the filters and let
them dry before re-installing them. Insert the dust container filter into the top part of the coarse filter. After attaching the
filter, attach the top part of the coarse filter and align the unlock symbol with the arrow symbol on the coarse filter. Turn
the coarse filter clockwise until the arrow is next to the unlock symbol. Place the filter unit back into the dust container.
Place the dust container back into the appliance body.
CP3010
EN
Fig. 5
59