Maintenance - Concept CP 3000 Bedienungsanleitung

EN
USE & MAINTENANCE

Maintenance

1. When finished steam cleaning, ensure to turn off the appliance and unplug from the mains.
2. Empty the remaining water from the water tank.
3. Remove the mop pad. Microfibre pads can be washed in a washing machine, up to 100 °C. For heavily
soiled pads, soak them in warm water with detergent or a mild stain remover beforehand. Allow the pads
to dry completely before storing. NOTE: DO NOT USE FABRIC SOFTENER
Changing the Water Filter
The water filter will help filter minerals that reduce the effectiveness of the steam cleaner. Depending on
water conditions and use frequency, the filter should be replaced every 80-100 hours.
The steam mop will work using ordinary tap water. However, if you live in an area with hard water, the minerals
that form the hard water will reduce the life of the water filter installed in the steam mop. This will eventually
allow deposits to build up on the heat element of the appliance, which will reduce its performance. To prolong
the life of your filter and heater, we recommend using distilled or de-mineralized water.
WARNING: Unplug the cord from the mains before maintenance.
Outlet Filter Maintenance
Push the filter cover tab down and remove it from the appliance body.
Remove the filter from the back of the cover and wash it until it is
completely clean. Before returning the filter, allow it to dry thoroughly.
Put the filter cover back into the appliance - align the bottom of the
cover with the appliance body and rotate it to its place. It snaps when it
is in the right place.
Dirt tanks
Remove the filter unit from the dirt tank. Turn the coarse outer filter
counterclockwise and release it. Turn the main filter counterclockwise and
release it. Remove the outer foam filter from the bottom of the main filter.
Clean all the filters and let them dry properly before assembly. Place the
foam filter on the bottom of the main filter. Put the main filter back into
the case. Turn the main filter clockwise until it locks into place. Place the
foam filter on the bottom of the main filter. Put the main filter back into
the case. Turn the main filter clockwise until it locks into place. Place the
coarse outer filter on the main filter and align the unlock symbol with the
arrow symbol on the coarse filter. Turn the coarse outer filter clockwise
until it snaps and locks into place. Return the filter unit back to the dirt
tank. Place the dirt container back into the appliance body.
48 CP 3000