Cleaning And Maintenance; Troubleshooting - Concept CP 2000 Bedienungsanleitung

EN

CLEANING AND MAINTENANCE

IMPORTANT: ALWAYS ENSURE THE CLEANER HAS FULLY COOLED DOWN BEFORE PERFORMING ANY
MAINTENANCE TASKS.
Empty the Water Tank
1. Disconnect the cleaner from the mains and ensure the appliance has cooled down.
2. Release the Water Tank from the main body of the cleaner (3).
3. Remove the Water Tank cap.
4. Pour out any excess water from the tank (16). Put the cap back and secure it.
Changing and washing the Textile Pad
1. Disconnect the cleaner from the mains and ensure the appliance has cooled down.
2. Remove the Carpet Glider first if necessary and then remove the Textile Pad from the Head (18).
3. Wash the Textile Pad in a washing machine with a mild detergent at maximum temperature of 40 °C.
IMPORTANT: Do not use bleach or fabric softener when washing the Textile Pad.
Changing the Water Filter
The cleaner is fitted with a water filter. lf you live in an area with hard water the filter will discolour over time.
Depending on the water hardness and frequency of use the filter should be changed every 6 months.
1. Disconnect the cleaner from the mains and ensure the appliance has cooled down.
2. Release the Water Tank from the main body of the cleaner (3).
3. Remove the Water Filter from the appliance (19). Replace the old filter with a new one.
4. Put the Water Tank back.
NOTE: The state of the filter will affect the cleaner performance.

TROUBLESHOOTING

If a problem occurs, look at this chart first. If that does not help, contact a service centre.
The steam trigger does not work.
• Check the appliance is connected to the mains.
• Check the power cord.
No vapour comes out of the steam nozzle.
• Maybe there is no water in the water tank.
• Maybe the water tank is not properly installed in the appliance.
The textile pad does not clean.
• The pad may be too saturated with dirt and needs to be washed. See the Maintenance section.
60
CP 2000