Inserting / Replacing Batteries; Initial Use; Switching The Product On And Off - Silvercrest SDRF 10 A1 Bedienungs- Und Sicherheitshinweise

Plug the power supply
connect the product to the mains.

Inserting / replacing batteries

Remove the battery cover to open the battery compartment
the back of the product. If applicable, remove the used batteries.
Insert four batteries type 1.5 V LR6 AA (not included). Ensure cor-
rect polarity. Note the markings inside the battery compartment
Reinstall the battery cover until you hear it lock into place to close
the battery compartment
Note: To see the battery status, press the Menu / Info button
the colour LCD
tion in the colour LCD

Initial use

Switching the product on and off

The product will only display the clock, date and alarm times in standby
mode when using the product with the power supply
powered, the colour LCD
on with the button
Switching on / off on mains power:
Fully extend the antenna
Set the main switch
The product is now in standby mode. The colour LCD
the current date and the time, as well as the alarm settings for
alarm 1 and alarm 2.
Press the button
product for the first time it will automatically scan for DAB+ stations
after being switched on. The progress bar in the colour LCD
into a properly installed mains socket to
19
.
6
several times (see chapter "Displaying informa-
1
"). The battery level is shown in percent.
1
will be blank until the product is switched
1
.
8
for good reception.
7
at the back of the product to position „On".
5
to switch on the product. When using the
8
at
6
6
on
10
. When battery
19
shows
1
1
GB/MT
.
59