Dismantling; Setting Up The Device; Connecting The Power Supply; Inserting Batteries - Silvercrest SKR 800 C3 Bedienungsanleitung Und Sicherheitshinweise

Dismantling

♦ Pull the device forwards off the mounting plate
♦ Unscrew the screws (
mounting plate

Setting up the device

You can also set up the device on a level surface. So as not to cover the venti-
lation slots and speakers
adjustable foot
♦ Reach into the recess on the side of the adjustable foot
far as it will go.
♦ Select a suitable location for the device (also see the section "Set-up location
requirements").

Connecting the power supply

CAUTION
► Before connecting the device, compare the connection data (voltage and
frequency) on the rating plate on the rear of the device with that of your
electric supply. This data must agree so that the device is not damaged.
♦ Insert the plug into a mains power socket. The device starts an automatic
station search and saves the stations that can be received in the max.
30 preset slots. After the station search, the
system) flashes briefly on the display. If there is a suitably strong RDS signal,
the time and date will be set automatically. If the RDS signal is too weak,
the time display (
date must be set manually.

Inserting batteries

You can prevent the programmed time, preset stations and alarm times from
being lost in the event of a power failure by inserting 2 x 1.5 V batteries (type
AA/Mignon/LR6). The batteries ensure that the internal clock continues to run
even during a power failure. The display
is restored, the correct time automatically appears on the display
NOTE
► The device can also only be operated using the mains power connection
without batteries. Operation using the batteries only is not possible.
► If there is a power failure and no charged batteries are in the battery
compartment
♦ Open the battery compartment cover
■ 90 │ GB │ MT
g h
or ) on the mounting plate and remove the
u
from the wall cupboard.
s
on the bottom of the device, you must fold out the
p
of the device:
) will appear on the display
d
, all the settings you have carried out will be reset.
u .
p
display (RDS - radio data
4 and the time and
4
will go out, however. When power
d on the bottom of the device.
and pull it out as
4
.
SKR 800 C3