Safety Instructions For Batteries; Before Use; Unpacking; Inserting / Replacing The Power Reserve - Silvercrest SKR D1 A1 Bedienungs- Und Sicherheitshinweise

Safety instructions for
batteries
m
DANGER TO LIFE! Keep batteries out of
reach of children . If accidentally swallowed
seek immediate medical attention .
Swallowing may lead to burns, perforation of
soft tissue, and death . Severe burns can occur
within 2 hours of ingestion .
DANGER OF EXPLOSION!
Never recharge non-rechargeable
batteries . Do not short-circuit
batteries and open them . Overheating, fire or
bursting can be the result .
Never throw batteries into fire or water .
Do not exert mechanical loads to batteries .
Risk of leakage of batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries, e .g .
radiators / direct sunlight .
If batteries have leaked, avoid contact with
skin, eyes and mucous membranes with the
chemicals! Flush immediately the affected
areas with fresh water and seek medical
attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries can
cause burns on contact with the skin .
Wear suitable protective gloves at all times if
such an event occurs .
In the event of a leakage of batteries,
immediately remove them from the product to
prevent damage .
Remove batteries if the product will not be used
for a longer period .
30 GB/IE
Risk of damage of the product
Only use the specified type of battery!
Insert batteries according to polarity marks (+)
and (–) on the battery and the product .
Use a dry lint-free cloth or cotton swab to
clean the contacts on the battery before
inserting!
Remove exhausted batteries from the product
immediately .
˜ Before use
˜ Unpacking
Remove all packaging materials (including
foils) . Check if all parts are present .
˜ Inserting / Replacing the
power reserve
NOTE: This product uses a battery to backup
the time of the clock, alarm times and the radio
stations .
Open the battery compartment 14 .
Insert 2 batteries (type: 1 .5 V, AA/LR6) into
the battery compartment 14, following the
polarity marks .
Close the battery compartment 14 .
˜ Requirements for the set-up
location
For the safe and trouble-free operation of the
product, the set-up location must fulfill the following
requirements:
When setting up the product, place it on a firm,
flat and horizontal surface . Use the fold-out
foot 12 .