AEG RMB96719CX Benutzerhandbuch Seite 27

7. Remove three 8mm bolts from both
top hinges.
8. To gain access to lower hinge,
drawer will need to be extended.
Unscrew the three lower hinge
screws and slide the hinge inwards
Lift up on door and remove from
bottom hinge.
Lower Hinge Removal
CAUTION
Be sure doors are set aside in
a secure position where they
cannot fall and cause personal
injury, or damage to the doors
or handles.
9. To reinstall doors, reverse procedure.
IMPORTANT
Make sure water line tubing
goes through hole at top of
dispenser pocket. There is also
a metal wrap on the tubing to
prevent damage from the hinge
rubbing against it. This needs
to be fixed back around the
tube in the proper location upon
reinstallation (just as long as the
tube is protected from the hinge).
NOTE
When reinserting the water tube
and replacing the top hinge
cover, use care to be sure the
tube does not kink.
Once both doors are in place, ensure
they are aligned with each other and
level (Please see the Installation section
for more details), and replace the top
hinge cover.
12.2 To remove the
MultiSwitch/MultiChill
drawer
1. Fully open drawer.
2. Remove basket from drawer.
3. Unclip harness at front of drawer
and move harness out of the way
of drawer slides.
4. Press liner clips and slide rail past
clips on both sides to fully remove
drawer from cabinet.
5. Reverse the steps to reinstall
the drawer.
12.3 Removing Freezer Drawer
CAUTION
Drawer is heavy. Use caution
when lifting.
1. Open drawer and fully extend.
2. Remove the freezer drawer.
3. Remove the freezer basket.
4. Inside the cabinet, press the two tabs
on both sides to release the sliders.
5. Remove the drawer with brackets
and sliders.
ENGLISH 27