Working Advice - Bosch UniversalDetect Originalbetriebsanleitung

Follow the instructions in the information area on the touchscreen when recalibrating.
Only carry out the recalibration at room temperature.
<Help menu> menu
To open the <Help menu> menu, lift the measuring tool off the substrate and
press the button with the symbol shown opposite.
Submenu <Product information>:
Here you will find information about your measuring tool.
Submenu <Tips>:
You can choose whether you want the instructions on using your measuring tool to be
shown every time you switch it on. In this submenu, you can also choose to view the tips
directly.
Submenu <FAQ>:
Here you will find information about the most common measuring errors.
Submenu <Online help>:
A website address is given here where you will find further information about your meas-
uring tool.

Working Advice

Marking objects
If required, detected objects can be marked. Perform a measurement as usual.
Once you have found an object, mark its position through the marking hole (5).
The symbol shown on the measuring tool may change while you are making this mark as
the marking hole is directly in the sensor area (6) and the pen you use may disturb the
sensors.
Always start a new measurement after marking a position. You can do this by lifting the
measuring tool off the wall and then putting it down again. This will ensure that the mark-
ing process does not affect the measuring results that follow.
Errors – Causes and Corrective Measures
Cause
Measuring process does not start.
Wall sensor (8) has not detec-
ted contact with the wall.
Measuring results inaccurate/implausible
Bosch Power Tools
Corrective measures
Briefly press the on/off button (2) to start the measuring
process manually.
English | 27
1 609 92A 6H8 | (02.07.2021)