Einbauen/Anbauen
1.1 Anbringen der CU an dem PM
1.1
Anbringen der CU an dem PM
Anbringen der Control Unit am Power Module
Die Control Unit wird so am Power Module angebracht, wie in nachstehendem Bild
dargestellt. Mit einem Druck auf die Freigabetaste auf der Oberseite des PM kann die CU
wieder entfernt werden.
Das Verfahren zum Anbringen der Control Unit am Power Module ist immer gleich,
unabhängig davon, welche Kombination von Control Unit und Power Module benötigt wird.
Bild 1-2
Vorsicht
Before snap-on the Control Unit to the Power Module while hot swap connect 24 V supply to
the terminals.
1-2
Anbringen der Control Unit am Power Module
Betriebsanleitung (kompakt), 2006-04-04, A5E00807487A AA
Control Units CU240S