Inhaltsverzeichnis
Werbung
2.4
Location
The machine should be kept away from flammable and explosive materials and away from direct sunlight
and intense light. The machine should also be placed in a well-ventilated place.
The machine must be set up on a sufficiently firm base, if necessary in accordance with the minimum
requirements of the information in the foundation plan.
When choosing the place of installation, in addition to the nature of the floor, the guidelines and
instructions of the accident prevention regulations and the workplace ordinance must be observed.
When installing on floor ceilings, their sufficient load-bearing capacity must be checked. In general, it is
advisable to consult a building expert for an assessment when installing on floor ceilings.
The machine is only to be installed and used in closed rooms. It has no corresponding safety features (e.g.
IP protection, galvanized design, etc.).
Temperature
Sea level
Humidity
2.5
Electrical connection
The general and local regulations must be observed. Therefore, this step may only be
carried out by a trained specialist.
Pay attention to the necessary supply line (see technical data).
The connection should be made with a 230V Schuko plug or a 5-phase 16 A CEE plug (partially supplied).
Voltage deviations should be a maximum of 0.9 - 1.1 times the nominal voltage range and the frequency
deviation should be 0.99 - 1.01 times the frequency range.
In order to be able to guarantee this, necessary protective measures must be taken.
At the end of the work, the direction of rotation of the motor must be checked.
® Urheberrecht ATH-Heinl GmbH & CO.KG, Alle Rechte vorbehalten / Druckfehler und technische Änderungen vorbehalten / Stand: 2021-07
4-40 °C
< 1500 m
50% at 40°C – 90% at 20 °C
Produkthersteller ATH-Heinl GmbH & CO.KG
- 11 -
Werbung
Kapitel
Inhaltsverzeichnis
