About This Manual; Indications For Use; Contraindications; Overview - Nds surgical imaging ZERO WIRE DUO Benutzerhandbuch

About This Manual

This manual is designed to assist the user with installation, setup and operation of the NDS ZeroWire® Duo
HD wireless video system.
2
A black numbered tab on the side of the page denotes the beginning of a section.
The functional descriptions in this manual are representative of:
Part Numbers:
90T2014 = Receiver
90T2015 = Transmitter (Input: DVI)
90T2016 = Transmitter (Input: DVI and 3G-SDI)
Manual Part Number: 60G0396 Rev D
Indication for Use
The NDSsi ZeroWire Duo HD Wireless Video System is a paired transmitter and receiver, intended for
delivery of video signals over a radio-frequency link to a video display during endoscopic and general
surgical procedures. The ZeroWire HD Wireless Video System is a non-sterile reusable device not intended
for use in the sterile field. It is intended for use by qualified physicians having complete knowledge of
these surgical procedures.

Contraindications:

1. These units are non-sterile reusable devices and are not intended for use within a sterile field.
2. This equipment may not be used in the presence of flammable anesthetics mixture with air, oxygen
or nitrous oxide.
For mission critical applications, a replacement DVI cable and a BNC terminated coaxial cable shall
be immediately available.

Overview

The ZeroWire Duo transmitter and receiver pair allows wireless delivery of video signals from the DVI or
HD-SDI output of an endoscopic camera processor or other video source to the DVI input of a video
display. It operates as an unlicensed ultra-wideband (UWB) wireless system in compliance with FCC (Part
15) rules governing UWB.
The system is composed of a transmitter (Tx) and a receiver (Rx) pair. The Tx unit is designed to be
mounted on the rear top edge of a display on a surgical cart, or on the cart itself. The transmitter may
obtain its input video signal from either an endoscopic camera processor or the display's re-drive output.
The Tx unit is powered from the provided 24 VDC power supply ("wall-wart") or through the optional 'Y'
adapter cable*. The 'Y' adapter cable is described on page 6.
The Rx unit is designed to be mounted on the rear top edge of a display, it may also be mounted on a cart,
and is powered from the provided 24 VDC power supply ("wall-wart") or through the optional 'Y' adapter
cable*. The 'Y' adapter cable is described on page 6.
A typical installation is shown on page 9.
*Note: The 'Y' adapter cable is for use with NDS 19", 24", 26" and 32" Radiance and 24" EndoVue displays
only.
1