Typical Installation; All Channels In Use Indication; Performance - Nds surgical imaging ZERO WIRE DUO Benutzerhandbuch

Typical Installation

Display hardwired to
image source (processor).
For patient safety a display that is hard wired to the video source shall be immediately
available whenever a surgical procedure is in progress.

All Channels In Use Indication

Tx Indication:
1. When all channels are in use and a new ZeroWire pair or a new Tx is turned on: The LED on the Tx will
alternate between blue and yellow continuously or until it finds a free channel. If a free channel is
found, then the LED will behave as described in Bonding Procedure on page 8.
2. When all channels are in use and the bonding button is pressed on a new Tx. The LED on the Tx blinks
fast yellow, indicating that the device is attempting to bond. If no channel is found, then the LED blinks
alternately until the bonding times out. If an available channel is found, then the LED will behave as
described in Bonding Procedure on page 8.
Rx Indication:
Rx is not aware that all channels are in use.

Performance

Performance:
ZeroWire HD Wireless Video System products are intended and optimized for use in a surgical
operating room (OR). Use outside of an OR environment is not recommended.
The following steps will help you to achieve optimal performance of the ZeroWire system:
1. Mount both components at least 1.5 meters (5 feet ) from the floor.
2. Ideally, both the transmitter and receiver should be at the same height.
3. For a reliable video link, the distance between transmitter and receiver should be 10 meters (30 feet) or
less .
4. The black surfaces of the transmitter and receiver should be vertical, facing each other and be visible to
each other in free air space. We do not recommend orienting the modules horizontally.
9
Transmitter Receiver