Nds surgical imaging ZERO WIRE DUO Benutzerhandbuch Seite 11

32" and 37" Radiance Displays:
Select 'T' bracket (P/N 20C0684). Lay the display face down on a clean surface. Center the 'T' bracket on the
top edge of the display and remove the 2 screws that are aligned with the holes in the bracket. Insert the
provided screws through the bracket and case back. Tighten both screws. With the black surface of a
ZeroWire Rx or Tx module facing the front of the display, align the slot on the bottom of the module with
the top of the bracket and push the module down on the bracket until the module seats.
42", 52" and 55" Radiance Displays:
Select 'T' bracket (P/N 20C0668). Lay the display face down on a clean surface. Center the 'T' bracket on the
top edge of the display and remove the 2 screws that are aligned with the holes in the bracket. Insert the
provided screws through the bracket and case back. Tighten both screws. With the black surface of a
ZeroWire Rx or Tx module facing the front of the display, align the slot on the bottom of the module with
the top of the bracket and push the module down on the bracket until the module seats.
Typical ZeroWire installation on a NDS
Radiance 37.
Typical ZeroWire installation on a NDS
Radiance 42.
4