Replacing The Power Cable - EINHELL TE-VC 2350 SACL Originalbetriebsanleitung

You can use the supplied electric tool adaptor
(Fig. 3/22) to connect the suction hose (9) to the
electric tool. To do so, fit it between the suction
hose and the extractor port on the electric tool.
n
Set the switch (7) on the wet and dry vacuum
cleaner to position AUTO, automatic mode. The
moment you switch on the electric tool, the wet
and dry vacuum cleaner switches on as well.
When you switch off the electric tool, the wet and
dry vacuum cleaner switches off as well after a
pre-set delay.
6.5 Blowing
Connect the suction hose (Fig. 1/9) to the blow
connector (Fig. 2/19) on the wet and dry vacuum
cleaner.
6.6 Filter cleaning system (Fig. 20a-20b)
The equipment has a filter cleaning system which
enables large amounts of fine dust to be suc-
tioned without fitting the dirt collector bag.
Important! The filter cleaning system is only allo-
wed to be activated if the coarse filter is fitted!
Important! The filter cleaning system can only be
activated if the equipment is in operation!
If there is a drop in suction performance, the filter
cleaning system can be activated at the touch of a
button in order to clean the dirty coarse filter and
increase the suction performance again.
Actuate the cleaning button (1) six times while
the equipment is in operation with the end of the
suction hose. Keep the button pressed down for
4 seconds each time you actuate it. Ensure that
the suction hose does not become kinked when
you do so.
6.7 Cleaning the appliance head (Fig. 1/5)
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the appliance.
Anl_TE_VC_2350_SACL_SPK13.indb 21 Anl_TE_VC_2350_SACL_SPK13.indb 21
GB
6.8 Cleaning the container (Fig. 1/10)
The container can be cleaned with a damp cloth
and some soft soap or under running water, de-
pending on the amount of dirt.
6.9 Cleaning the filters
Cleaning the pleated filter (Fig. 3/24)
Clean the pleated filter (24) regularly by carefully
patting it and cleaning it with a fine brush or hand
brush.
Cleaning the foam filter (Fig. 3/25)
Clean the foam filter (25) with a little soft soap un-
der running water and allow it to air-dry.
Cleaning the coarse filter (Fig. 3)
Clean the coarse filter (16) with a little soft soap
under running water and allow it to air-dry.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 21 -
26.01.2021 13:52:58 26.01.2021 13:52:58