Replacing The Power Cable; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-VC 1930 SA Originalbetriebsanleitung

6.5 Blowing
Connect the suction hose (11) to the blow con-
nector (10) on the wet and dry vacuum cleaner.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend that you clean the equipment
immediately after you use it.
8.2 Cleaning the equipment head (3)
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the equipment.
8.3 Cleaning the tank (8)
The tank can be cleaned with a damp cloth and
some soft soap or under running water, depen-
ding on the amount of dirt.
8.4 Cleaning the fi lters
Cleaning the pleated fi lter (15)
Clean the pleated fi lter (15) regularly by carefully
patting it and cleaning it with a fi ne brush or hand
brush.
Cleaning the foam fi lter (16)
Clean the foam fi lter (16) with a little soft soap un-
der running water and allow it to air-dry.
8.5 Maintenance
At regular intervals and before each use, check
that the fi lters in the wet and dry vacuum cleaner
are securely fi tted.
Anl_TC-VC_1930_SA_SPK9.indb 17 Anl_TC-VC_1930_SA_SPK9.indb 17
GB
8.6 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 17 -
22.05.2017 09:53:41 22.05.2017 09:53:41