Carrier XCT7 Installations- Und Bedienungsanleitung Seite 11

Operation
Swing
(1) Press MENU key, to enter function cycle, use
Down swing or Left/Right swing, and press MENU key again to enter the swing angle setting (applicable for some
models). Use or
(2) After adjustment, if there is no input within 10 seconds or MODE / FAN key is pressed, the swing setting interface
will close and previous changes are not saved.
Note:
When the communication protocol which the wired controller adopts is of second version, the up/down swing and left/right swing, or
only the up/down swing is controlled by dip switch SW7. (When the communication protocol is the third or first version, SW7 is not
applicable)
Health airflow up/down function (applicable to some models)
(1) Press MENU key to enter function circulation, use
(health airflow up) or
When the function is successfully set, the corresponding icon will be displayed on the main interface.
(2) Health airflow up/down function cannot be set at the same time. When the latter function is set, the former will be
canceled automatically.
(3) If health airflow up/down function is set, and if you adjust the swing angle, the health airflow up/down function will
be cancelled.
Sleeping
(1) Press MENU key to enter function cycle,
sleeping function, the sleeping time will display by
key to enter sleeping time setting, use
sleeping time is from 0.5h to 72h, Press MENU key to confirm.
(2) When the sleeping time is up, the controller will turn off.
(3) If the sleeping function is on, when you switch to the sleeping function in the function cycle, pressing MENU key
will turn it off.
(4) If controller is turned off when the sleeping function is turned on, the sleeping function will be cancelled.
Heat Reclaim Ventilation
(1) Press MENU key to enter function cycle, and use key to switch between different functions. Switch to
function, then press MENU key again to turn on HRV function. If the function is turned on,
displayed in the main interface.
(2) If the HRV function is turned on and you want to turn it off, please enter function cycle and switch to
then press MENU key. The function will be turned off.
Switch between Fahrenheit and Celsius
(1) If the current temperature is displayed in Celsius, adjust temperature in each mode to 30°C (when energy saving
function is set currently, the parameter in heating mode will be the highest limit value). Press
switch to Fahrenheit. The interface will display 86°F (when energy saving function is set, its highest limit value of
Fahrenheit will be displayed).
(2) If the current temperature is displayed in Fahrenheit, setting temperature should be adjusted to 60°F in each
mode (when energy saving function is being set, the parameter in cooling/dry mode will be the lowest limit value).
key to adjust the swing angle. After adjustment, press MENU key to exit the setting.
(health airflow down) function, then press MENU key again to set the function.
use
or
or key to switch between different functions. Switch to the Up/
or key to switch between different functions. Switch to
or key to switch between different functions. Switch to
the which is on the top-left corner. Press TIME
key to adjust the sleeping time by 0.5h increments. The range of
7
icon will be
icon,
okey for 15s to