Kampa Loo Loo Montage- Und Bedienungsanleitung Seite 7

• seasonal pitch or commercial use
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Kampa reserves the right to change product
appearance and product specifications.
Using the tent
Before first use
Familiarize yourself with the product by carrying
out a test set up before the product is used for the
first time. Check if the scope of delivery is
complete.
Choosing a site
Choose a flat site that is protected from wind:
1. If necessary, use a windbreak.
2. Choose a shaded site to avoid UV degradation
of the fabric.
3. Avoid pitching under trees as falling branches,
resin, etc. can damage the product.
4. Clear the site of sharp stones and debris to
avoid damaging the groundsheet.
5. Set up the product with the doors facing away
from the wind.
Setting up the tent
A
NOTICE! Material damage
Do not open or close the zippers by
force.
I
NOTE
• The tent comes with general purpose
• Drive the pegs at a 45° angle away
• Peg the guy lines in line with the seam
Keep the following tips in mind while setting up the
tent:
• The figures provide a general overview of the
set-up. The actual set-up will vary slightly based
on the model of tent.
• Get help. The set-up is easier with more people.
• Thread the poles through the outer sleeves.
• After standing the tent upright, check the corner
pegs and re-peg if necessary.
• Peg the guy lines so that the tent is under tension
without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the tent as follows:
1. To protect the tent from dirt and damage, lay
down a groundsheet or footprint before
unpacking.
2. Unpack the tent.
3. Separate and identify the different compo-
nents.
4. Proceed as shown to set up the tent (fig. 2,
page 3 – fig. 8, page 5).
After each use
1. Leave the door open for a while for good ven-
tilation and air exchange.
2. If used as a shower tent, wipe the surfaces
inside the tent dry with a damp cloth.
4445103366
pegs. These will be suitable for many
sites but for some types of ground spe-
cial pegs will be needed. Ask your
dealer.
from the tent into the ground.
it starts from.
7