Safety; Proper Use - Kaco blueplanet 50.0TL3 Betriebsanleitung

1 | General information
2

Safety

Before using the product for the first time, please read through the safety instructions carefully.
The electrician is responsible for observing all existing standards and regulations. The following applies:
– Keep unauthorised persons away from the device and/or system.
– In particular, making sure that the locally applicable version of the standard
stallations or locations – solar photovoltaic (PV) power supply systems" is observed.
– Ensure operational safety by providing proper grounding, conductor dimensioning and appropriate protec-
tion against short circuiting.
– Observe all safety instructions on the product and in these operating instructions.
– Switch off all voltage sources and secure them against being inadvertently switched back on before per-
forming visual inspections and maintenance.
– When taking measurements on the live device:
– Do not touch the electrical connections
– Remove all jewellery from wrists and fingers
– Ensure that the testing equipment is in safe operating condition.
– Modifications to the surroundings of the device must comply with the applicable national and local stand-
ards.
2.1

Proper use

The device is a transformerless PV inverter which converts the direct current of the PV generator into grid-com-
patible three-phase alternating current and then feeds the three-phase alternating current into the public
power grid.
The device is built using state-of-the-art technology and in accordance with the recognized safety rules. Never-
theless, improper use may cause lethal hazards for the operator or third parties, or may result in damage to the
product and other property.
The device is intended for indoor and outdoor applications and may only be used in countries for which it has
been approved or for which it has been released by KACO new energy and the grid operator.
Operate the device only with a permanent connection to the public power grid. The country and grid type se-
lection must be commensurate with the respective location and grid type.
The requirements of the grid operator must be met for grid connection to take place. The permission of the rel-
evant authorities may also be required in order to secure authorisation to connection to the grid.
The enclosed documentation is an integral part of the product. The documentation must be read, observed and
stored in a place which is freely accessible at all times.
The name plate must be permanently attached to the product.
Any other or additional use of the device shall be regarded as improper.
This includes:
– Use of a distribution system that is not described (grid type)
– Use of sources other than PV-strings.
– Mobile use
1
Country
EU
USA
Tab. 1: Examples of standards specific to business premises
2
WARNING! The blueplanet 60.0 TL3 is not intended for use in residential areas and cannot ensure ad-
equate protection of radio reception in such environments.
Page 6
Operating Instruction I
1
Standard
Harmonised document - HD 60364-7-712 (European im-
plementation of the IEC standard)
PV section of NEC 690 and sections in article 100, 690.4,
690.6 and 705.10
KACO blueplanet 50.0 TL3 KACO blueplanet 60.0 TL3
"Requirements for special in-
2