Accessories; Guidebar And Saw Chain Combinations - Husqvarna 525PT5S Bedienungsanweisung

1
Noise emissions
Sound power level, measured according to ISO
22868,dB (A)
2
Sound levels
Equivalent sound pressure level at the operator's ear, measured according to ISO 22868, dB(A):
Equipped with approved accessory (original)
3
Vibration levels
Vibration levels at handles, measured according to ISO 22867, m/s
Short shaft, front/rear handles
Extended shaft, front/rear handles

Guidebar and saw chain combinations

Recommended guide bar and saw chain combination.
Guide bar
Length, in/cm
10/25
12/31
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
1
Reported data for the noise output level has a typical dispersion (standard deviation) of 2 dB (A).
2
Reported data for equivalent sound pressure level for the product has a typical statistical dispersion (standard
deviation) of 1 dB (A).
3
Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1 m/s
712 - 007 - 28.04.2021
Pitch, in
1/4
525PT5S
107
89
2
:
6.3/5.3
4.1/6.7

Accessories

Note:
This guide bar deviates from the Husqvarna
standard and must be of type A318 to fit the product.
Gauge, in/mm
0.050/1.3
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
Saw chain
Type
Husqvarna H00
Length, drive links,
no.
58
64
2
.
25