Starting The Chain Saw; Shutting Off The Chain Saw - Toro Flex-Force Power System Bedienungsanleitung

Starting the Chain Saw

1. Ensure that the vents on the chain saw are free
from dust and debris
1. Side vent
2. Set the chain saw down on a level surface.
3. Align the tongue of the battery pack with the
battery cavity in the chain saw
4. Push the battery pack into the battery cavity until
the battery pack locks into place.
5. Remove the protective cover from the chain.
6. Ensure that the chain brake is in the O
position (Figure 8).
(Figure 6).
Figure 6
2. Bottom vent
(Figure 7).
Figure 7
PERATING
1. Chain brake (O
position)
g315701
7. With your left hand on the front handle and your
right hand on the rear handle, press the trigger
lock, then squeeze the trigger
1. Front handle
2. Chain brake
3. Trigger lock

Shutting Off the Chain Saw

g315702
To shut off the chain saw, release the trigger.
Whenever you are not using the saw or are
transporting the saw to or from the work area, move
the chain brake to the S
remove the battery pack.
10
Figure 8
2. Chain brake (
PERATING
position)
(Figure
Figure 9
4. Trigger
5. Rear handle
position (Figure
TOP
g315703
STOP
9).
g315704
8) and