D) Function G4 "Program Copy - Sygonix TX 4 Bedienungsanleitung

d) Function G4 "PROGRAM COPY"

This function is used to copy the entire programme (times/tem-
peratures) of a specifi c day to another day.
Proceed as follows:
1. After selecting this function G4 "PROGRAM COPY" and con-
fi rming with "OK" (2), the number of the weekday fl ashes at
the upper edge of the display and "PROGRAM COPY" appears
in the bottom display line.
2. Select the day for the source programme with the buttons "–"
(5) and "+" (6).
3. Confi rm the selection with "OK" (2). The bottom line shows
"PROGRAM PLASTER".
4. Select the day for which you want to overwrite the programme
with the source data with the buttons "–" (5) and "+" (6).
Overwriting deletes any times/temperatures of the target day
that may be saved.
To cancel copying, push the "MENU" (3) (repeatedly if re-
quired) as usual.
5. Confi rm the selection with "OK" (2). The bottom line now
shows "PROGRAM SUCCEED". The data were copied.
6. The number for the weekday fl ashes at the upper edge of the
display again, and "PROGRAM PLASTER" appears in the bot-
tom display line.
If desired, you can copy the source data to another day. Con-
tinue with step 4.
To leave the copying function and return to the regular dis-
play, push the button "MENU" (3), repeatedly if required.
65