Maintenance; Recommended Maintenance Schedule(S); Adjusting The Self-Propel Drive - Toro 22275 Bedienungsanleitung

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 25 hours
Before each use or daily
After each use
Every 40 hours
Every 50 hours
Every 100 hours
Adjusting the Self-Propel
Drive
If the machine is new, does not self-propel, or it tends
to creep forward, adjust the drive cable.
1. Move the machine outside and onto a paved
surface near a solid wall to safely prevent the
machine from moving forward while the motor
is turned on.
2. Position the machine with the front tires against
the wall.
Note:
Ensure that the area is well ventilated
and clear of debris that could be thrown by the
machine.
3. Start the motor; refer to
(page 17).
4. Pull the self-propel-drive bar to the handle.
Note:
The wheels should start to turn as the
self-propel-drive bar just touches the handle.
5. Shut off the motor.
6. If you must adjust the machine, do the following:
•
If the wheels do not spin when you engage
the self-propel-drive bar, the traction belt is
too loose. Rotate the wheel-drive-control
knob (Figure
steps 3 through 5.
Maintenance Procedure
• Tighten any loose fasteners.
• Inspect the mower blades for wear or damage.
• Inspect the accelerator for wear or damage.
• Check the stopping time of the blade brake. The blade must stop within 3 seconds
of releasing the blade-control bar; if it does not, contact an Authorized Service
Dealer for repair.
• Clean the underside of the machine.
• Clean the wheels and gears.
• Sharpen or replace the blade. Maintain it more frequently if the edge dulls quickly in
rough or in sandy conditions.
• Tighten any loose fasteners.
Starting the Machine
22) clockwise 1 turn and repeat
1. Wheel-drive-control knob
•
If the wheels spin before you fully engage
the self-propel-drive bar, the traction belt
is too tight. Rotate the wheel-drive-control
knob (Figure
and repeat steps
7. For a new traction belt, rotate the
drive-cable-adjustment knob clockwise 1
additional turn to allow for the normal stretching
of the belt during the break-in period.
Note:
You can skip this step if you are adjusting
a used belt.
23
Figure 22
22) counterclockwise 1 turn
3 through 5.
g024465