Safety Regulations - TERMA MEG Gebrauchsanweisung

All manuals and user guides at all-guides.com
User Manual
Our products have been designed and manufactured in
such a way to ensure that all the quality, functionality
and aesthetic requirements are met. We would like to

Safety regulations

Please read the below instructions thoroughly and study
the images carefully.
1. Never use the device that is damaged in any way.
2. Please check if the tally voltage equals the voltage
of the electric installation in your home prior to con-
necting the device.
3. Please check regularly if the power wire is not dam-
aged and if the device can be used in a safe manner.
4. Power wire is not subject to repair. Damaged power
wire should be replaced at the manufacturer's or
specialised repair shop.
5. Always connect the device to the grounded installa-
tion (socket with earthing pin). For devices without
the plug (ie. connected directly to installation),
please see below colour codes for each wire:
Colour Letter code
Brown L
Blue N
Yellow & green PE
6. The heating element is intended to work in a liquid
agent environment. It is advised not to turn the de-
vice on in dry conditions for longer than 5 seconds.
Do not touch metal parts — burning risk. Always
make sure that the wire does not touch the heating
element that is hot.
7. The device must not be connected while being
installed. Unplug the device or disconnect the power
wire from electrical circuit.
8. Do not open the casing.
9. Do not allow for the casing of the control head to get
14
User manual Meg, Moa, Reg 2, Reg 3 www.termagroup.pl
congratulate you on this great purchase and wish you
a pleasant use.
10. Do not touch the electric device while standing in
11. Heating element's electric output cannot exceed
12. Pressure inside the radiator must not exceed the
13. An air pillow of the correct parameters should
14. In case of a dual fuel radiator (connected to the
Wire type
Live
Neutral
Earthing
15. The device is intended for home use.
16. The device is not intended for use by children,
17. Heating element without plug should be installedby
flooded or splashed with water or any other liquid.
the bathtub, shower or barefoot on the floor.
100% heating output of the radiator for the follow-
ing parameters: 75/65/20° C.
pressure value recommended by the radiator's
manufacturer or the pressure of 10 atmospheres for
the heating element. Exceeding of recommended
pressures may result in the radiator or heating ele-
ment damage and cause possible threat for health,
life and property.
always be allowed for inside an electric radiator (see
chapter Installation).
central heating system) one of the valves should be
left open prior to turning the heating element on and
during its operation in order for the excess water
created due to its heat expansiveness to be pushed
out. Leaving both valves closed will result in exces-
sive pressure growth which may lead to damaging
of the heating element or radiator (see chapter Dual
fuel radiator / Installation).
persons with limited mental capacity or those who
do not have sufficient knowledge or experience
required for handling this type of equipment. In such
cases, control or training by persons responsible for
safety of the above mentioned is required.
a qualified fitter only.