Aqua Computer LEAKSHIELD Betriebs- Und Montageanleitung Seite 7

aqua computer
LEAKSHIELD
By a short press on the button, it is possible to navigate directly through the display
pages.
If the button is pressed for longer than one second, the menu is displayed.
At this moment, "MENU" appears briefly in the display, followed by the menu
items.
By shortly pressing the key, you can now select between the following items:
SHIELD (mode selection)
Complete protection and detection of leakages. This function can only be used re-
liably after a configuration via the aquasuite!
MONITOR (mode selection)
The system is monitored for leaks by using a low negative pressure. There is no
protection against leakage in this mode.
RELEASE (mode selection)
The LEAKSHIELD system is switched off. The vacuum is automatically released, and
pressure equalization occurs automatically.
TESTER (Action)
In this action, a leak test of the cooling system is enabled. A configurable negative
pressure is generated as a test pressure and then the pressure loss is displayed.
FILL (Action)
This action makes it possible to suck coolant into the system. A vacuum of between
250 and 300 mbar is generated for this purpose.
DEAERATION (action)
This action supports the venting of the system during filling by cyclically generating
and releasing negative pressure.
LEVEL SENSOR (action)
The measurement of the level in the reservoir is triggered by this action. This functi-
on can only be used appropriately after configuration via the aquasuite!
EXIT
Exit the menu.
The respective function is selected by pressing the key again for a longer than 1
second.
© 2020 Aqua Computer GmbH & Co. KG - 7 -
Gelliehäuser Str. 1, 37130 Gleichen