LEAKSHIELD
overwrite the previously saved data, so the file always contains only the most re-
cent data set. Select "Automatic data export" below the "Data log" headline in the
listing to access the settings screen. Create a new export data set by clicking the
plus symbol in the upper right corner of the screen. Enter name, path and time in-
terval to meet your requirements. You may then add the data sources to log by
clicking the plus symbol in the "Data sources" window section. You may add an
unlimited number of data sources to each export data set, the total number of ex-
port data sets is also unlimited.
10. Page "LEAKSHIELD"
Click on the "LEAKSHIELD" device page below the "LEAKSHIELD" entry.
The most important LEAKSHIELD functions are visualized and triggered
on this page.
In the right view you see an overview page. In the upper area, the most important
information about LEAKSHIELD is displayed. This includes the current vacuum, the
required vacuum for protection against leakage, the status, the current fill level of
the reservoir and the current volume change in the system.
The "Mode" display informs you about the current operating mode of your LEAKS-
HIELD. By clicking on this area you can change the modes.
The following modes are available:
SHIELD (Complete protection by negative pressure and leak detection)
•
MONITOR (Low negative pressure, leak detection only)
•
RELEASE (System is switched off, automatic pressure compensation)
•
Below follows the an area „Action" where you can select important device functi-
ons directly by clicking on one of the symbols.
The following actions are available:
Test:
•
Measure fill level:
•
Deaerate system:
•
Refill system:
•
Depending on the currently selected action, the further display of the lower area of
this page changes.
- 14 -
Test the cooling system for leaks
Measure the level in the reservoir.
Supports the venting of the system during filling
Suck coolant into the system
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
aqua
computer
© 2020