Door Opening - Electrolux LLI9VF54X0 Benutzerhandbuch

22 www.electrolux.com
11.3 Positioning
This appliance is not intended to be
used as a built-in appliance.
This appliance should be installed in
a dry, well ventilated indoor position.
This appliance is intended to be used
at ambient temperature ranging from
10°C to 43°C.
If, due to different installation, proper
ventilation requirements are not
respected, the appliance will function
correctly but energy consumption might
increase slightly.
The correct operation of the
appliance can only be guaranteed
within the specified temperature
range.
If you have any doubts regarding
where to install the appliance,
please turn to the vendor, to our
customer service or to the nearest
Authorised Service Centre.
It must be possible to disconnect
the appliance from the mains
power supply. The plug must
therefore be easily accessible
after installation.
CAUTION
If you position the appliance
against the wall, use back
spacers provided or keep the
minimum distance indicated
in the installation instructions.
CAUTION
If you install the appliance next
to a wall, refer to the installation
instructions to understand the
minimum distance between the
wall and the side of the appliance
where door hinges are to provide
enough space to open the door
when the internal equipment is
removed (e.g. when cleaning).

11.4 Door opening

The refrigerator should be positioned
to allow easy access to a counter when
removing food. For best use of refrigerator
drawers and freezer baskets, the
refrigerator should be in a position
where both can be fully opened.
11.5 Cabinet Leveling &
Refrigerator Door Alignment
(if necessary)
Guidelines for final positioning
of refrigerator:
• All four corners of the cabinet must
rest firmly on the floor.
• The front should be slightly elevated
to ensure that doors close and seal
properly.
• Doors should align with each other and
be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer.
2. Lower anti-tip legs until they are both
touching the floor. Once on the floor,
use a pair of pliers to adjust.
To raise unit: turn leg clockwise.
To lower unit: turn leg
counterclockwise.
3. Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
To make final door height adjustments: