Herunterladen Inhalt Inhalt Diese Seite drucken

Installing Your New Appliance; Adjusting The Doors - Electrolux LLI9VF54X0 Benutzerhandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 266
5. INSTALLING YOUR NEW APPLIANCE
This section explains the installation of
the new appliance before using it for the
first time. We recommend reading the 
following tips.
WARNING!
For proper installation, this
refrigerator must be placed on
a level surface of hard material
that is the same height as the
rest of the flooring. This surface 
should be strong enough to
support a fully loaded refrigerator,
or approximately 250 kg. When
moving, be sure to pull out and
push back the unit in straight.
Class
Extend
Temperate
Temperate
Subtropical ST
Tropical
This appliance is not intended to be used
as a built-in appliance.
Leveling of appliance
For proper leveling and avoid vibration,
this appliance is provided with adjustable
feet in front. Please adjust the level by 
following below instructions:
1. Roll the refrigerator into place.
2. Turn the adjustable feet (with your
fingers or a suitable spanner) until 
they touch the floor.
3. Tilt back the top backwards for about
10-15 mm by turning the feet 1~2
turn further. This will allow the doors
to selfclose and seal properly.
Symbol
Ambient
Temperature
rage (°C)
SN
+10 to +32
N
+16 to +32
+16 to +38
T
+16 to +43
4. Whenever you want to move the
appliance, remember to turn the
feet back up so that the appliance
can roll freely. Reinstall the appliance
when relocating.
WARNING!
The rollers, which are not castors,
should be only used for forward or
backward movement. Moving the
refrigerator sideways may damage
your floor and the rollers. 

Adjusting the doors

• Both left and right doors are equipped
with adjustable axes, which are located
in the lower hinges.
• Before adjusting its doors, please
ensure that the refrigerator is level.
Please review the previous section on 
"Leveling appliance". If you find the 
top of the doors are uneven, insert the
Allen wrench into the hinge axis, and
turn it clockwise to rise the door or
anticlockwise to lower the door, and
insert an E Ring into the gap.
EN
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis