Change Of Door Opening Direction - Electrolux ERC 07002W8 Benutzerinformation

14 electrolux

Change of door opening direction

Should the setting-up or handling
demand it, door-opening direction can be
refitted from right-handed to left-handed.
Following operations are to be done on
the basis of figures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder
off, unscrew the screws fixing the top
door holder (2 pieces) and take it off
according to figure.
Take the door off.
Remove the screw fixing the lower
door holder and the other screw fixing
the lower door holder and the foot.
Then remove the door holder and the
foot as shown in the Figure.
Loosen the screw fixing the foot
opposite the lower door holder in
order to remove the foot.
Fix the door
corresponding foot on the opposite
side and then the other loosened foot
at the former place of the door holder
as shown in the Figure.
Please make sure to place
the lower foot below the
door holder. The lower foot is
recognizable by its 4 ribs on the
outer surface.
Fit the door to the lower door holding
pin.
GB
holder and
To fit top door holder remove plastic
coverings of door holder holes
carefully (e. g. with a knife) and put
them on the other side.
Fix top door holder with 2 screws in
the place set free being careful that
the edge of the door is parallel with the
side of cupboard.
Put the covering of top door holder
back.
Put over the handle and the plastic
nails on the other side.
In case you do not want to perform the
procedures above, call the nearest
brand-mark service. Technicians will
accomplish the refitting expertly for
charge.
the
GB