Operation - Jinbei DMII-4 Anleitung

1) General notes on commissioning
• Please check the scope of delivery for completeness:
1 x Jinbei DM II studio flash, 1 x protective cap, 1 x mains cable 4.5
m, 1 x instruction manual .
• Before using the flash for the first time, please read the operating
instructions completely and observe all warnings and safety inst-
ructions .
• Mount the flash on a lamp tripod, lock it in place using the lamp
tripod lock [3]. Adjust the tilt of the flash with the tilt lock [2].
• Remove the protective cap from the flash tube. To do this, pull the
bayonet release button [b] to the rear, turn the protective cap to
the left and remove it to the front .
• Put on the desired light shaper / flash umbrella. The flash unit is
equipped with an umbrella holder for reflector/translucent umbrel-
las and the Bowens S-type bayonet [a] for the use of a wide variety
of light shapers (softboxes, reflectors, beauty dishes, etc.).
a) Bowens S-type bayonet (3x)
b) Bayonet release
c) Bayonet pins
(3x on the light shaper)

Operation

a
c
25
b