Jinbei DMII-4 Anleitung Seite 38

• Do not film car, bus, bicycle, motorbike or train drivers while driving
with this product . The driver may be blinded and cause an acci-
dent . This also applies to unlisted persons or groups if possible
glare could cause an accident .
• Do not shine directly into the eyes of people or animals as this may
cause damage to the retina, visual disturbances and even blind-
ness .
• Ensure adequate ventilation during operation . Never cover the
ventilation slits of the unit .
• Do not use or store the unit in high temperatures or in closed
rooms with direct sunlight . The product should not be used in am-
bient temperatures above 40°C .
• Please note that the flash tube, modelling light and a connected
reflector can become very hot during operation. Do not touch
these parts during or immediately after operation . Allow the unit
components to cool down before replacing the flash tube or reflec-
tor .
• Handle glass parts such as the flash tube with care so that the
glass is not broken. Do not touch the flash tube with bare hands,
use clean cotton gloves or a microfibre cloth. Small residues of skin
grease can cause the flash tube to burst.
• Make sure that the flash tilt lever is firmly tightened before using
the unit and connecting accessories to it .
• Mount the flash unit on a tripod with sufficient load-bearing capa-
city and set up the tripod so that it cannot tip over or slip .
• Allow the flashgun to cool down before packing it for transport or
storage .
Safety Instructions
38