Jinbei DMII-4 Anleitung Seite 28

1) Flash output setting
• The flash output from 3.0 to 9.0 can be set in 1/10 or whole f-stop
increments . The maximum power is shown in the display [10] as 9 . 0 .
• To adjust in 1/10 f-stop increments,
press the Minus-button [9] or the
plus button [16] to the desired value .
• For adjustment in whole f-stop
steps, keep the minus button "-" [9]
or the plus button "+" [16] pressed
for a longer time .
Test flash
• Press the test button [13] to trigger a test flash.
• With a green signal, the test button [13] indicates that
the capacitor is fully charged and the flash is ready to
flash again. When the flash is ready, an acoustic signal
Test
sounds at the same time, provided it is switched on with
the button [12] .
Modelling light / acoustic signal
• With a short press on the button [12], you switch the modelling light
on and off and select between proportional power, 100% power
and off . The symbol [26] appears on the display .
• When the modelling light is switched on, it also functions as a visu-
al ready indicator for the flash charging process. When a flash is
triggered, it switches off. When the flash is ready again, it switches
on again . If the acoustic signal is switched on, the modelling light
does not function as a visual ready indicator .
• A long press on the key [12] switches the acoustic signal on and off .
The symbol [25] appears on the display .
Operation
28