Notes On Changing The Flash Tube - Jinbei DMII-4 Anleitung

EasyCap-Modus
Long press the SET key [18] to activate EasyCap mode . The corre-
sponding icon [27] appears in the display .
Briefly press the "minus" or "plus" key [9/16] to set "1" for the first flash,
"2" for the second flash and "1/2" to end the EasyCap mode and con-
firm your entry by briefly pressing the SET key [18].

Notes on changing the flash tube

Please note the following instructions for changing the flash tube:
Make sure that the unit is switched off and disconnected from the
power supply. Wait until the flash tube has cooled down before
changing it. Always use clean cotton gloves or a microfibre cloth to
change the flash tube.
Fig. 1: Unwind the twisted ignition wire from
the flash tube holder and carefully pull the
flash tube out of the unit.
Operation
Fig. 2: To insert a new flash tube, support
the legs of the flash tube and carefully push
the flash tube into the end position. Then
wrap the ignition wire around the flash tube
holder again .
31