Jinbei DMII-4 Anleitung Seite 30

Radio channels and groups
Press once the SET button [18] to set the desired radio
channel from "0" to "31". The display starts flashing. Press
the minus button "-" [9] or the plus button "+" [16] to set
the possible values . The set value is automatically con-
firmed after 2 seconds.
Press the SET key [18] again to set the desired group to
A – J / L / O / P / Q / S / U. The display starts flashing. To
set the values in question, press the "Minus" key [9] or
the "Plus" key [16]. The set value is automatically confir-
med after 2 seconds .
Note: The values set on the flash for channel and group must match
the values set on the radio remote control . Group settings are not
available with the TRS-V radio remote control .
Photocell / Slave mode
Please press buttons [17] and [18] simultaneously to switch the
photocell (infrared sensor) for slave mode on or off . The symbol [24]
appears on the display. Now the flash is triggered via the flash light
of other flash units (studio, camera, clip-on/system flash) or via an
infrared remote trigger .
Note: Please note that this method of triggering is highly dependent
on the environment and the positioning of the individual flash units
in relation to each other .
Note: It is not guaranteed that all camera models are always suppor-
ted . There may also be restrictions in functionality or in combinations
of different technical possibilities .
Operation
30