Hoover Robot Cleaner Bedienungsanleitung Seite 9

MAINTAINING YOUR ROBOT CLEANER
Before performing any maintenance task, ensure the robot is switched off.
1. Turn the robot off and remove it from the charging station.
2. Use a damp cloth to clean all surfaces. DO NOT allow water into any part of the product whilst
cleaning.
3. Dry with a soft cloth.
EMPTYING THE DUST CONTAINER
After vacuuming, remove the dust container.
1. Press the dust container release buttons and pull it out. [Fig. 17]
2. Hold the dust container over a dust bin and empty it. [Fig. 18]
3. Use the cleaning brush when necessary to remove any excess dust from the internal surface of the
dust container or filter surface.
4. Refit the dust container to the robot.
CLEANING THE FILTERS
The robot is fitted with a pre-motor filter. To maintain optimum cleaning performance, regularly clean
and wash the filter cover and the pre-motor filter. It should be cleaned after the dust container has been
emptied 5 times. Failure to clean your filter may result in air blockage overheating and product failure.
This may invalidate your guarantee.
1. Turn the robot off and remove from the charging station.
2. Press the dust container release button and remove the dust container from the Robot. [Fig. 17]
3. Remove the filter and clean. [Fig. 19] The assembly is done in reverse order.
Make sure, that the filter insert is correctly assembled.
IMPORTANT: Regularly check and maintain the filter by following the filter maintenance instructions.
This will maintain your Robot's performance.
IMPORTANT: Always ensure the filter is fully dry before use.
CLEANING THE AGITATOR
Regularly clean the agitator to maintain maximum cleaning performance.
1. Turn the Robot off.
2. Turn the Robot over.
3. Press the clips on the soleplate and remove the agitator cover. [Fig. 20]
4. Remove the agitator and clean away any hair or fibers Etc using scissors or with the cleaning brush
provided. [Fig. 20]
CLEANING THE DRIVE WHEELS
1. Switch the Robot off and turn it over.
2. Remove any dirt or hair trapped in the wheels.
3. Clean the wheels with a dry cloth. [Fig. 21]
CLEANING ANTI FALL SENSORS
To maintain the safe operation of your robot it is important to keep the Anti fall sensors clean.
There are 2 sensors located on the underside of the robot. Turn the robot upside down and clean them
with a soft brush to remove any accumulation of dust, dirt or debris. [Fig. 22]
IMPORTANT NOTICE
Only use approved replacement parts for your Robot.
Using parts not validated by Hoover are dangerous and will invalidate your guarantee.
If the Robot will not to be used for several months, please remove the batteries and store in cool a dry
location.
IMPORTANT: Always make sure your device is switched off before maintenance.
* Certain Models Only
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
GB
9