Hoover Robot Cleaner Bedienungsanleitung Seite 7

Removal and replacement
Ensure the robot is switched OFF.
Locate the battery compartment under the robot's dust container and remove the two screws.
Remove the battery from the compartment and disconnect the connector.
Refit a new battery and reconnect the connector. Pay attention to correct alignment of the connector.
Refit the battery cover and the two screws. [Fig. 6]
Virtual Wall Magnetic Strip* Setup
The robot comes with Virtual wall Magnetic Strip*. These strips create a physical threshold that
prevents your robot crossing. You can use scissors to adjust the size of the stripe for greater
customization. [Fig. 7]
Place the magnetic strip in a doorway to prevent it entering or leaving a particular room.
USING YOUR ROBOT CLEANER
Power On
1. Press the ON/OFF power button on the side of the robot. [Fig. 8]
2. The product display will illuminate.
In standby mode, the display is off. To activate the robot press the the start/ pause button on the
remote control or on the product.
Set time
1. Press the Timeset button on the remote control, a flashing line will appear below the day icon. [Fig. 9]
2. Use the right and left arrow on the remote control until the line appears below the correct day. Press
the Start/Pause button to confirm.
3. The hour display will flash. Press the up and down arrow on the remote control until the correct hour
is displayed. Press the Start/Pause button to confirm.
4. The minute display will flash. Press the up and down arrow on the remote control until the correct
minute is displayed. Press the Start/Pause button to confirm.
5. Day and time are now set.
APP DOWNLOAD AND CONNECTION VIA THE WIFI*
In order to access all the Robot's functions from anywhere, it is suggested to download the hOn App.
You will be able to control the Robot in the most efficient way.
App advantages:
• Control your robot in an easy and intuitive way
• Activate the cleaning process from anywhere
• Carry out settings and daily scheduling
• Choose between its different and customized cleaning programs
Instructions:
1. Download the hOn application from the App Store or Google Play. [Fig. 10]
2. Open the APP, create an account with your e-mail and a password.
3. Confirm login.
4. Ensure your mobile device is connected to WiFi.
5. Log into the hOn APP.
6. Press the ON/OFF power button on the side of the robot. [Fig. 8]
7. Switch the WiFi ON by pressing the WiFi button on main product. [Fig. 11]
8. Press and hold the WiFi button on main product for 5 seconds, there will an audible beep and the
WiFi button will start flashing to indicate it is waiting for a connection. [Fig. 11]
9. Follow the in APP instructions to connect your mobile device to your product.
10. When successfully paired, the WiFi button on the product will remain illuminated.
11. To reset the WiFi, press & hold the WiFi button om main product for 5 Secs.
WARNING
• The WiFi name cannot exceed 32 characters.
• If the network configuration fails to connect, follow the below steps:
a) Make sure to have inserted correct router WIFI password.
b) Make sure to set your WiFi network to 2.4GHz.
c) Make sure the robot is not far away from the router.
* Certain Models Only
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
GB
7