Hoover Robot Cleaner Bedienungsanleitung Seite 6

GB
6
PREPARE YOUR ROBOT CLEANER
PACKAGING
Do not dispose of your Robot packaging. It may be required for the validity of your guarantee in the
future.
When unpacking your Robot and its accessories, take care to keep plastic bags away from babies,
young children and animals to avoid the risk of suffocation.
Before first use, charge your appliance for 8 hours. [Fig. 1]
Do not expose the Robot's mains power adaptor to temperatures below 0°C or above 30°C as this may
damage the battery.
The mains power adaptor must only be connected to a standard mains power outlet.
Fig. 1
BATTERY
For optimum battery performance it is recommended that you keep your robot batteries fully charged.
When the robot is not in use it should be left connected to the mains power adaptor. The robot has an
intelligent charging system. This prevents the batteries from becoming overcharged.
To avoid accidents, make sure that every person in the room is aware of the presence of the Robot.
Charging station Setup
Before use, remove obstacles that may get in the path of the Robot. Pay attention to:
• Objects that can be easily knocked over.
Fig. 2
• Edges of carpets or rugs that it may get caught on.
• Floor length curtains and tablecloths.
• Heat sources or flammable items.
• Power cords and cables.
• Fragile objects.
Plug in the mains power adaptor and connect to the charging station. [Fig. 2]
1. Make sure the power cord is not caught underneath the charging station.
2. Place the charging station on a non-reflective level floor, preferably against a wall. If the floor surface
Fig. 3
is too reflective, it will interfere with the Robot navigation system and it may have difficulty locating the
charging station.
3. There should not be any objects in the area around the charging station for 2 meters in front and 1
meter to each side. [Fig. 2]
4. Make sure the power cord is not tangled or stretched. If there is an excess, use the power cord
storage on the rear of the charging Station.
5. Check that the dust container is inside on Robot.
Remote Control Setup
Open the battery compartment on the back of the remote control. Insert two AAA / LR03 batteries into
the battery compartment. [Fig. 3] Observe the correct polarity (+/-).
Charging the battery
Switch on the vacuum robot with the on/off button on the side ( I ). [Fig. 4] Set it down in front of the
charging station.
Guide your Robot into the charging station to begin. During normal use, it will take approximately 4/5
hours to complete a full recharge.
Fig. 4
Manual charging
There are several methods to charge your robot.
A. By pressing the Home charging button on your remote control.
B. By pressing the Home charging button on your robot.
C. By connecting the mains power adaptor directly to the robot.
D. By manually placing the robot on the charging station.
E. Following the instruction in the WiFi Application*.
Automatic charging
When the robot battery capacity is LOW it will stop cleaning and search for the charging station. Once
docked with the charging station, the charging indicator on charging station will flash.
The robot may fail to reach the charging station if there are too many obstacles in between it and the
Fig. 5
charging station. For best results ensure that the charging station is in a wide open space.
NOTE: Make sure that the charging contacts of the robot vacuum cleaner and charging base are not
dirty. Clean the contacts if necessary.
It is normal for the charging base and vacuum cleaner to become warm during charging.
When the battery is charging, Power Indicator LED on the charger base and the Battery Level Indicator
on product's display flash. If the battery is fully charged, they are on permanently. [Fig. 5]
Battery
Over time the capacity of your robot battery will diminish and it will need to be replaced. A replacement
battery can be purchased from an approved Hoover retailer. Only use genuine Hoover spares and
accessories.
Fig. 6
* Certain Models Only