Troubleshooting - cecotec CONGA ROCKSTAR Bedienungsanleitung

ENGLISH
with warm water. Dry them thoroughly before installing them back in the device.
To take filters out:
Open the dust tank following the instructions on the before section.
Turn the metallic filter anticlockwise and remove it.
Fig. 13
Unscrew the plastic cyclone and remove it too.
Pull from the tab located on the top of the handheld vacuum cleaner and remove the high-
efficiency filter.
Wash all of them with warm water.
Allow them to dry completely before installing and using them again.
Fig. 14
Jalisco brush
Recommendation: It is important to clean the brush regularly to avoid hair and other foreign
objects from tangling and to prevent blockages.
Press the brush release button on the bottom part of the suction base and remove the brush.
Wash it with warm water. Do not use detergents or soap.
Make sure it is completely dry before installing it back in the device.
Fig. 15

6. TROUBLESHOOTING

Problem
The motor does not operate.
Suction power level is very
low
Green and red light blinking.
The operating time after
charging has decreased.
Note: For any further doubt, please contact the official Technical Support Service of Cecotec.
32 CONGA ROCKSTAR 700 X-TREME ERGOFLEX
Possible reason
No battery.
The vacuuming tube, brush,
battery, suction base or
handheld vacuum cleaner are
not assembled in place.
The dust tank is full.
Filters are dirty or blocked.
Air inlet of the vacuuming
tube or suction base are
blocked.
The charger is not connected
to the mains.
It has not been enough
charged.
Battery is damaged or too old.
Solution
Charge the vacuum cleaner.
Check that the components
and the handheld vacuum
cleaner are assembled
correctly.
Empty the dust tank.
Clean or replace the filter.
Clean the dirt attached to the
brush.
Plug the charger to a socket
base.
Charge the battery
completely.
Replace the battery.