After Finishing Work; Transporting; Storing; Cleaning - Stihl KMA 130 R Gebrauchsanleitung

English
► Push the release slide (1) forwards, hold it
briefly in that position and allow it to spring
back.
This selects the next power level. Power level
3 is followed by power level 1, then 2, 3.
► Push the release slide (1) forwards and allow
it to spring back as many times as necessary
to select the required power level.
Every KombiTool can be operated with all three
power levels.
11.3 Operation
The method of operating the KombiMotor
depends on the KombiTool you are using.
► Operate the KombiMotor as described in the
instruction manual supplied with the Kombi‐
Tool.

12 After Finishing Work

12.1 After Finishing Work
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
► If the KombiMotor is wet: Allow the KombiMo‐
tor to dry.
► Clean the KombiMotor.

13 Transporting

13.1 Transporting the KombiEngine
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
Carrying the KombiEngine
► Carry the KombiEngine properly balanced by
the shaft with the KombiTool behind you.

17 Troubleshooting

17.1 Troubleshooting the KombiMotor and Battery
Condition LEDs on Bat‐
tery
KombiMotor 1 LED flashes
does not run green.
when switched
on.
1 LED glows
red.
3 LEDs flash
red.
3 LEDs glow
red.
28
Transporting the KombiEngine in the car
► Secure the KombiEngine so that it cannot turn
over or move.

14 Storing

14.1
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
► Mount the KombiTool as described in the
instruction manual supplied with the Kombi‐
Tool.
► Check the following points when storing the
KombiMotor:
– KombiMotor is out of the reach of children.
– KombiMotor is clean and dry.

15 Cleaning

15.1
► Switch off the KombiMotor and pull the con‐
necting cable plug out of the socket.
► Clean the KombiEngine with a damp cloth.
► Clean vents with a paintbrush.

16 Maintenance and Repairs

16.1
The KombiMotor cannot be serviced or repaired
by the user.
► If your KombiMotor has a malfunction or is
damaged or requires servicing: Contact your
STIHL servicing dealer for assistance.
Cause
Battery has low
charge.
Battery too hot or too
cold.
There is a malfunction
in the KombiMotor.
KombiMotor is too
hot.
12 After Finishing Work
Storing the KombiMotor
Cleaning the KombiEngine
Servicing and Repairing the
KombiMotor
Remedy
► Recharge the battery fully as described
in the instruction manual for the STIHL
AL 101, 300, 500 chargers.
► Pull the connecting cable plug out of the
socket.
► Allow battery to cool down / warm up.
► Pull connecting cable plug out of the
socket and then refit it.
► Switch on the KombiMotor.
► If 3 LEDs continue to flash red: Do not
use your KombiMotor and contact your
STIHL servicing dealer for assistance.
► Pull the connecting cable plug out of the
socket.
0458-805-9621-B