Specifications; Noise And Vibration Data - Stihl KMA 130 R Gebrauchsanleitung

18 Specifications

Condition LEDs on Bat‐
tery
4 LEDs flash
red.
KombiMotor cuts 3 LEDs glow
out during opera‐ red.
tion.
KombiMotor run‐
time is too short
18 Specifications
18.1 STIHL KMA 130 R KombiMotor
Approved batteries:
– STIHL AR
– STIHL AP together with "AP belt bag with
connecting cable"
– Weiight without KombiTool: 3.2 kg
For battery life see www.stihl.com/battery-life.
18.2

Noise and Vibration Data

STIHL recommends that you wear hearing pro‐
tection.
The exact noise and vibration specifications
depend on the KombiTool being used and are
described in the KombiTool's instruction manual.
– Sound pressure level L
ISO 11201, ISO 22868: 76 dB(A) up
to 91 dB(A) K-value for noise pressure level is
2 dB(A).
0458-805-9621-B
Cause
There is a malfunction
in the battery.
No electrical contact
between KombiMotor
and battery.
KombiMotor or battery
damp.
KombiMotor is too
hot.
There is a electrical
malfunction.
Battery not fully char‐
ged.
Normal battery life
has been exceeded.
to EN ISO 10517,
pA
Remedy
► Allow the KombiMotor to cool down.
► Pull connecting cable plug out of the
socket and then refit it.
► Switch on the KombiMotor.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Pull connecting cable plug out of the
socket and then refit it.
► If KombiMotor still does not start when
switched on: Clean contacts of connec‐
ting cable as described in the STIHL AR
battery's instruction manual or in the
user instructions for the "AP belt bag
with connecting cable".
► Allow the KombiMotor or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow the KombiMotor to cool down.
► Pull connecting cable plug out of the
socket and then refit it.
► If KombiMotor continues to cut out
during operation: Clean contacts of con‐
necting cable as described in the STIHL
AR battery's instruction manual or in the
user instructions for the "AP belt bag
with connecting cable".
► Switch on the KombiMotor.
► Recharge the battery fully as described
in the instruction manual for the STIHL
AL 101, 300, 500 chargers.
► Replace the battery.
– Sound power level L
ISO 10517, ISO 22868: 86 dB(A) up
to 102 dB(A) K-value for sound power level is
2 dB(A).
– Vibration value a
hv
with ISO 8662, ISO 10517, ISO 11789,
ISO 20643, ISO 22867
• Control handle: 1.5 m/s² up to 5.0 m/s². K-
value for vibration level is 2.0 m/s².
• Loop handle:
• 2.0 m/s² up to 5.0 m/s². K-value for vibration
level is 2 m/s².
The vibration values quoted above have been
measured according to a standardized test pro‐
cedure and may be used to compare electric
power tools. Depending on the type of usage,
the vibrations that actually occur may differ from
the values quoted. The vibration values quoted
may be used for an initial assessment of the
user's exposure to vibrations. The actual expo‐
English
to ISO 3744,
wA
measured in accordance
29