Emptying The Collection Tank; Emptying The Water/Detergent Tank; Filling The Water/Detergent Tank; Filling The Chem-Dose Tank (Accessory) - Tennant T291 Bedienungsanleitung

Emptying the collection tank

If the tank is full, the display shows the corresponding alarm, see the chapter "Display alarms";
after a few seconds, the suction motor shuts down, then stop the machine and empty the tank
following the instructions shown below. To resume work, turn the operation selector to the OFF
position (reset errors):
Take the machine to the disposal area.
Unhook the hose from the clip.

Emptying the water/detergent tank

To empty the tank, follow the instructions shown below:
Take the machine to the disposal area.
Stop the machine.
Detach the hose (Fig.12A-Rif.1) from its holder and unscrew the cap (Fig.12A-Rif.2).
Lower the hose, and open the tap (Fig.12A-Rif.3) to empty the tank.

Filling the water/detergent tank

tap (Fig.12A-Rif.3) on the hose (Fig.12A-Rif.1). This sequence of steps will allow air to escape from
detergent in the tank directly from the exposed hose.
14, Ref. 1). The machine is equipped with a graduated measuring cap that can be used to dilute the
detergent inside the tank. If the tank is empty, the display shows the corresponding alarm, see the
chapter "Display alarms"; to resume work, turn the operation selector to the OFF position (reset
errors).
(Fig.12A-Rif.2).

Filling the Chem-Dose tank (accessory)

Finishing work

Empty the dirty water tank and recharge the batteries

Moving the machine when not in operation

Proceed as follows to move the machine:
Raise the squeegee.
Raise the head.
Versions with mechanical drive: push or pull.
Version with electric drive: activate the drive lever.
! INFORMATION
ENGLISH
2
3
1
1
2
12
1
12A
13
1
14
20